Dropping a weighted line or fine flexible chain through a small hole will let you know if anything is blocking the space. These are horizontal pieces of wood bracing between the studs that will block you from running wires vertically. Running wires inside the wall is another matter. Take your time and you'll be much happier with the outcome. A little paint on the areas that are visible after mounting the TV and you're done. A little spackling will patch the bad holes. It should only take a few small holes to narrow down the location and center of the stud if you take time measuring, tapping and scannning. If you don't see wood on the bit when you take it out, move over. Go deeper than the lathe to be sure you are in wood. Go horizontally with about 1/2-inch spacing. Drill a series of holes with a small diameter bit in the area where you're pretty sure the stud is and where you want to put you anchor screws. Take some time and do all three until you have a good idea where a stud is in your target area (vertically and horizontally). Easiest way I have found to find studs for mounting heavy items is to estimate locations first by looking at existing outlets, tapping, and a deep scanning stud finder. I have a 90 year old house with same walls. Do you think that I could get away with 1 stud? It is after all only 80lbs and cheez has his on hooks not even in studs Last time I attempted to install a outlet box in the wall it was a disaster. My 2nd concern has to do with drilling out the lath so that I can run wires. Any suggestions?įrom what I understand, code at the time was studs are 16 inches apart. I guess I could use the old guess and check method but I would like a more precise method. The way lath and plaster is constructed it makes it impossible to use a conventional stud finder. My first problem area is finding the studs. Yes, I did a search and just found mentionings of lath and plaster but no concrete information on how to wall mount this beast. I am going to be mounting my new TH-50PH9UK in my bedroom where the walls are lath and plaster construction. I mounted my old(er) TH-50PH9Uk in a new part of the house where the walls are drywall. Originally Posted by ptysell /forum/post/0
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |